matplace
Lithophane Moon Lamp with Wide Screw Base

Lithophane Moon Lamp with Wide Screw Base

by The QuickSilver · Printables

Print it for yourself

The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC (non-commercial)
Largest side
about 110 mm
Printing estimate
about 185 g of filament, 8 h 40 min
Price with us
from €20.50 (PLA, 1 pc)The exact price comes from the calculation once the file is uploaded.

About the model

This expands the usable diameter of the opening of the moon lamp base from <60mm to >70mm. I have included several adapters to fit two moon lamps as included below. Hopefully the screw thread bases make it easier to work the tolerances. One of my biggest complaints with the original design is that the tolerances were too tight, and I had to sand it down a lot.I printed all pieces at 0.2mm, and they seem to work fine. I did not use supports at all, and the top of the moon did reasonably fine. I also added a brim, just to ensure that the reduced footprint would adhere to the bed, but it's possible you may not need it.https://www.amazon.com/dp/B00CM5SVU2/This one has the smaller “candelabra” bulb, which fits the “wide_base_cap” adapter.https://www.amazon.com/dp/B0983887RK/This one has the standard medium bulb, which fits the “xxx_36mm” adapters.

Similar models