One Ring - Dual Print and Lithophane - Hueforge Print
MakerWorld · cyanidesugar
autor The QuickSilver · Printables
Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.
Nahrát soubor a vytisknoutThis expands the usable diameter of the opening of the moon lamp base from <60mm to >70mm. I have included several adapters to fit two moon lamps as included below. Hopefully the screw thread bases make it easier to work the tolerances. One of my biggest complaints with the original design is that the tolerances were too tight, and I had to sand it down a lot.I printed all pieces at 0.2mm, and they seem to work fine. I did not use supports at all, and the top of the moon did reasonably fine. I also added a brim, just to ensure that the reduced footprint would adhere to the bed, but it's possible you may not need it.https://www.amazon.com/dp/B00CM5SVU2/This one has the smaller “candelabra” bulb, which fits the “wide_base_cap” adapter.https://www.amazon.com/dp/B0983887RK/This one has the standard medium bulb, which fits the “xxx_36mm” adapters.
MakerWorld · cyanidesugar
matplace
MakerWorld · 3DPrintBunny
Printables · MeasureOnce
MakerWorld
Printables · Carl D
Printables · RetromanIE
Printables · LMF5000
Cookies a měření. Nezbytné cookies jsou vždy; měření návštěvnosti a reklamy jen s vaším souhlasem. Víc o cookies