Disney Ear and Bag Holder For Loungefly
MakerWorld · TheMidnightSmith
by martinconi · Printables
The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.
Upload the file and printThis is a replacement 1/4" and 3/16" shelf support pin featuring an L-shaped bracket design. Unlike standard cylindrical pegs, the flat bracket distributes the downward force of the shelf over a larger surface area, reducing stress on both the peg and the furniture wall. Recommended Print Settings: To achieve maximum strength and prevent the peg from snapping under shear stress, layer orientation is critical. Orientation: Print the model upside down with no supports. Do not print it standing upright. Printing flat forces the continuous filament paths to run lengthwise through the 1/4" or 3/16" cylinder, giving it shear strength. Perimeters (Walls): Set your walls to 4–6. Because the peg has a 1/4" or 3/16" diameter, this will essentially force the slicer to print the peg as solid, concentric rings, which is much stronger than using standard infill. Layer Height: 0.16mm or 0.20mm for a good balance of detail and excellent layer adhesion. Material: Engineering-grade materials like Nylon, ASA, ABS, or PETG are highly recommended to prevent the plastic from creeping under continuous load. Nylon is particularly recommended for its durability. ASA prints beautifully for this application, especially if you are using an enclosed, high-temperature setup. Metric version here: Disclaimer: Strength is dependent on material, settings, and print quality. Use at your own risk.
MakerWorld · TheMidnightSmith
matplace
Printables · LBcosplay
Printables · VogMan
MakerWorld · minivanbuzz
Printables · VogMan
MakerOnline · Aleandrus
Printables · fixumdude
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies