matplace
Heavy Duty 1/4" and 3/16" Shelf Pin / Peg (L-Shape Support Bracket) imperial

Heavy Duty 1/4" and 3/16" Shelf Pin / Peg (L-Shape Support Bracket) imperial

autor martinconi · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 45 mm
Odhad tisku
asi 8 g filamentu, 18 min
Cena u nás
od 85 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

This is a replacement 1/4" and 3/16" shelf support pin featuring an L-shaped bracket design. Unlike standard cylindrical pegs, the flat bracket distributes the downward force of the shelf over a larger surface area, reducing stress on both the peg and the furniture wall. Recommended Print Settings: To achieve maximum strength and prevent the peg from snapping under shear stress, layer orientation is critical. Orientation: Print the model upside down with no supports. Do not print it standing upright. Printing flat forces the continuous filament paths to run lengthwise through the 1/4" or 3/16" cylinder, giving it shear strength. Perimeters (Walls): Set your walls to 4–6. Because the peg has a 1/4" or 3/16" diameter, this will essentially force the slicer to print the peg as solid, concentric rings, which is much stronger than using standard infill. Layer Height: 0.16mm or 0.20mm for a good balance of detail and excellent layer adhesion. Material: Engineering-grade materials like Nylon, ASA, ABS, or PETG are highly recommended to prevent the plastic from creeping under continuous load. Nylon is particularly recommended for its durability. ASA prints beautifully for this application, especially if you are using an enclosed, high-temperature setup. Metric version here: Disclaimer: Strength is dependent on material, settings, and print quality. Use at your own risk.

Podobné modely