matplace
Easter Egg

Easter Egg

by xSteve · Printables

Print it for yourself

The licence (CC BY-NC-SA (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC-SA (non-commercial)

About the model

Print in spiral vase mode or normal with 0 top layers, 3 bottom layers, 1 wall. In normal mode you can use infill and print the eggs solid if you want. I printed in vase mode. Each egg file is solid and approximately 55mm wide and 70mm tall. The use of a brim or raft will be helpful to get the egg to stick to the bed. I also used support at 60 degrees to get the egg to stick to the bed. The eggs have a horizontal top end to the print, print slowly. Print instructions Nozzle size: 0.4 mm Layer height: 0.2mm Wall line width: 0.8mm recommended Print speed: 25mm/sec recommended Vase Mode enabled (spiralize outer contours in Cura) Enjoy!

Similar models