Easter Egg

O modelu

Print in spiral vase mode or normal with 0 top layers, 3 bottom layers, 1 wall. In normal mode you can use infill and print the eggs solid if you want. I printed in vase mode. Each egg file is solid and approximately 55mm wide and 70mm tall.  The use of a brim or raft will be helpful to get the egg to stick to the bed.  I also used support at 60 degrees to get the egg to stick to the bed.  The eggs have a horizontal top end to the print, print slowly.   Print instructions Nozzle size: 0.4 mm  Layer height:  0.2mm  Wall line width:  0.8mm  recommended Print speed:  25mm/sec recommended Vase Mode enabled (spiralize outer contours in Cura) Enjoy!