Vallejo, GSW, Army Painter Skadis full paint rack

About the model

A Vallejo paint holder, which utilises the full width of the 76x56cm Ikea Skadis peg board. A total of 140 paints can be stored per board. Model is split into 4 easy to print pieces over 2 beds. Print 4 of the standard holders and 1 upper. I wanted to get as much paint as I could onto the pegboard. You will be able to fit 5 x rows per board, each row will hold 28 x paints. I have tested it with Vallejo, Green Stuff World and Army painter. This is around 3 to 4 more paints per row than traditional holders. Please ensure that the rear pegs are supported across their length. The included 3mf are pre-supported. I have uploaded a STEP file for a better overall print if you decide not to use the 3mf. Also any adjustments/remix can be made if need be. Each part is numbered at the back. I'd suggest a minimum of 3 walls to ensure the pegs are strong enough. *** V2 now added following a request. This version allows you to see more of the bottle label and reduces the amount of filament, however it's strength will be effected. I have not tested this, so use at your own risk *** PLEASE NOTE. Due to their length, these holders are prone to warping. 3d printing and material properties mean that warping is always a risk. Please take steps to reduce this yourself by using glue stick, larger brims, etc. Bed adhesion and warping is not a model issue, I can't do anything about it.