matplace
Reolink E1 Pro Angled Stand - 2 versions (updated)

Reolink E1 Pro Angled Stand - 2 versions (updated)

MakerWorld

This model cannot be printed on matplace

Its licence (personal use only) does not allow printing to order. You can download the file at the source and print it yourself.

models to print
Licence
personal use only

About the model

Simple stand to enable the Reolink E1 Pro camera to look down just a bit more. Two versions: a very simple and straightforward V1 and a slightly more sophisticated V2 where the camera sits a bit more snug with holes to route the power cable nicely. I use this to keep an eye on my laser engraver from the other room to make sure it doesn't burn down the house… ;-) Note: The V2 version is just updated to v2a in an effort to accommodate the new camera version with the larger USB-C cable. • Adding some small rubber feet is recommended to avoid unnecessary moving around.

Similar models