Planter Vase Pot for ForgeCore Monstera Coaster Plant

About the model

This model features a small secret compartment to stash things. Treat the Outer Vase as the “lid” when stashing things so that stuff doesn't get in the way as you screw it together. It was originally designed around this Monstera Plant by ForgeCore. It's designed to fit the Dirt Base stl file included when you support ForgeCore on patreon. Printing Instructions No additional supports needed! 0.2mm layer height. The stl's included should be oriented in the position they are meant to be printed in. The Inner Vase has built in support. It doesn't have to look pretty where it's supported as that's where the dirt/plant is meant to go. It's recommended that you have your printer tuned for pressure advance and flow as the tolerance to insert the inner vase into the outer vase is only 0.2mm. I recommend cutting each model so you only have about an inch of each to see if they fit together. If you plan on scaling both models down to fit a smaller plant, there might be a little leeway, but because the two parts screw together you might not have a good time if the scale is too small as they may bind together too much. Assembly Vase_Inner and Vase_Outer screw together Feel free to join my discord for additional support, questions, or suggestions!