matplace
PARKSIDE Powerfix Clamp Replacement Jaw

PARKSIDE Powerfix Clamp Replacement Jaw

by Nikodem Bartnik · Printables

This model cannot be printed on matplace

Its licence (CC BY-NC-SA (non-commercial)) does not allow printing to order. You can download the file at the source and print it yourself.

models to print
Licence
CC BY-NC-SA (non-commercial)

About the model

Don't throw away your broken clamps! This is a heavy-duty replacement jaw for the Powerfix Profi+ one-handed clamps (commonly sold at Lidl), though it is designed to be compatible with many similar "budget" quick-grip clamps found at hardware stores. This model is a direct drop-in replacement. It is designed to reuse all your original hardware, including: • The original mounting screw and nut. • The original red rubber protective pad. Print Settings To ensure the part can handle the clamping force without delaminating, I recommend the following "overbuilt" settings: • Material: ABS or ASA (recommended for strength and slight flexibility). PETG is a good secondary choice. • Wall Loops: 6 (Essential for structural integrity around the bolt hole). • Infill: 50% (Gyroid or Cubic recommended). • Layer Height: 0.16mm (Provides better surface area for layer adhesion). • Supports: Yes (Required for the internal nut housing and overhangs). • Orientation: Print on its side for maximum strength (avoids the clamping force pulling against layer lines).

Similar models