P&O Cruises Iona and Arvia S1000 Single colour no support required

About the model

Update 4/1/24. Underwater hull parts are now available too - see multi coloured version of this model here https://makerworld.com/en/models/15006#profileId-14776 These models are a half size single colour reworks of my earlier 1:500 multi colour models. Some minor support structures have been included within the models - see yellow and red colour coding in order to allow them to print without slicer supports. I think it is ok to leave the yellow colour coded supports in place permanently - but I would recommend snipping off the red coded supports if you want to make the ship a little bit more authentic. Prints in about 8 hrs on a Bambu Lab X1C 0.4mm nozzle, 0.2mm layer height. STL files provided for each ship, plus pre-sliced Bambu Lab X1C/P1P 3mf print profile that contains both ships. 3 Test prints were done with Arvia - with the lighter green one in the photos being the final fully completed print. 6 Test prints were done on Iona - with the more complete model in BL PLA Silk Silver actually being the first test print - and having a few faults on it - which were gradually corrected with the smaller partial prints. It will print in PLA Silk - but some of the details like the little lamps on the top deck fail - so it is recommended just using Silver PLA - as per the last few partial prints. Filament for the test prints was sponsored by Bambu Lab. For background info about the development of these models see this forum thread. https://forum.bambulab.com/t/cruise-ship-print/5122/73 For timelapes of Iona and Arvia - see this youtube video. Youtube Modelled from photos and videos using Fusion 360. Single and Multicolour 1:1000 models on P&O Cruise ship Ventura also available on this site. Note that I have improved the text on this model when compared to ventura - by insetting the text 0.25mm, rather than it protroding 0.5mm like it does on the Ventura model. Multi colour versions of these models will probably be released once I have done some test prints - but note that they will take over 24 hours to print and will require a Bambu Lab X1C and 3xAMSs and lots of filament. This is a personal project. I have no connection to P&O Cruises or Carnival Corporation other than being a customer. Models hosted exclusively on Makerworld until Dec 2023. This version is released under a CC Non Commercial No Derivatives license due the P&O Cruises branding.