matplace
MYNT3D Printing Pen Stand

MYNT3D Printing Pen Stand

MakerWorld

This model cannot be printed on matplace

Its licence (personal use only) does not allow printing to order. You can download the file at the source and print it yourself.

models to print
Licence
personal use only

About the model

Was looking for a good stand for my Amazon MYNT3D Printing Pen that left the nozzle open if it was still hot. It should put the nozzle about 8mm or so off the surface and only the bigger of the 3 vents on the sizes of the nozzle is covered. PLA should be fine. I added a second version at a 45 degree angle if straight up and down doesnt work in your situation. I used PLA, but obviously PETG/ABS would be better. Supports: Yes for the center square.

Similar models