matplace
Medal holder - artistic dance design

Medal holder - artistic dance design

by Roary Labs · Printables

Print it for yourself

The licence (CC BY-NC-SA (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.

Upload the file and print
Licence
CC BY-NC-SA (non-commercial)

About the model

This is a medal holder that you can hang on your wall. Is made out of 5 parts, that can be mounted without glue or screws, just interference (there is a lot of interference, but if you push enough, you will be able to assemble it). If you have difficult sliding it in the lower part, use a little bit of oil lube and a rubber hammer. You must print it using SUPPORTS, between the parts where the 5 pieces are going to join. Be careful, remove all the excess otherwise you are going to have problems while mouting it. To hang on the wall you need this type of hooks: https://lc.cx/IwnjzK Credit to https://www.klipartz.com/it/sticker-png-bzwko for the figures used in this design If you have problems, contact me! If you like it, leave a like and a comment, thanks :)

Similar models