One Ring - Dual Print and Lithophane - Hueforge Print
MakerWorld · cyanidesugar
by RetromanIE · Printables
The licence of the model (CC BY (attribution)) allows commercial use too. Download the file at the source and upload it to us. We note the author and the source on the order for you.
Upload the file and printThese are mainly for use with the lithophanes available on Gadunky.com(but work on anything that will fit in them). They hold the lithophane at an 80° angle for best viewing(the flat section with the curve should be facing the back). Print with 100% infill in whatever material and colour you like(tested with PLA, PETG and ABS). A layer height of 0.2mm is a good balance between quality and print time on these. The height of the lithophane must also be considered when using a stand. These have been designed to comfortably hold a lithophane with a height 1.75x the length of the stand. So the 180mm version should hold a lithophane with a height of 315mm(180mm+75%) without falling over. In practice it will hold a much taller lithophane than this, but we only recommend up to 1.75x the length. If you need a particular size just comment and I'll add them. I need to know the length of the lithophane, thickness and how tall it will be. File name breakdown:- LithoStand-Gadunky.com-v3b-3.2mm-200mm.stl v3b: Version 3b of the stand design. 3.2mm: For use with 3.2mm thick lithophanes. 200mm: For use with 200mm in length (or smaller) lithophanes. All files follow this naming format. . Print instructions0.2mm layer height is perfectly fine for these. 100% infill,
MakerWorld · cyanidesugar
matplace
MakerWorld · 3DPrintBunny
Printables · MeasureOnce
MakerWorld
Printables · Carl D
Printables · RetromanIE
Printables · LMF5000
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies