matplace
Honeycomb monitor stand

Honeycomb monitor stand

by Erl · Printables

This model cannot be printed on matplace

Its licence (CC BY-NC (non-commercial)) does not allow printing to order. You can download the file at the source and print it yourself.

models to print
Licence
CC BY-NC (non-commercial)

About the model

Simple honeycomb end pieces I made for a monitor stand. Dimensioned for 1.5 cm thick plywood or similar. About 17.5 cm deep. I uploaded a version without and two versions with brackets. I also made a middle brace that can be put in the back to avoid sagging shelves if you make it very wide. Print instructionsI upped the bed temp to try to avoid warping in the corners. You can also try to warm the bed longer before printing to ensure it is properly warm all over, and print in an enclosure. I printed in PETG to avoid sagging on a hot summer day, and used three perimeters for added strength.

Similar models