matplace
HAS JAMMA Extender Slimline Case

HAS JAMMA Extender Slimline Case

by clintkolodziej · Printables

Do you have the file? Print it on our printer

The licence of the model (CC BY-SA (attribution, same licence)) allows commercial use too. Download the file at the source and upload it to us. We note the author and the source on the order for you.

Upload the file and print
Licence
CC BY-SA (attribution, same licence)
Largest side
about 180 mm
Printing estimate
about 78 g of filament, 3 h 40 min
Price with us
from €9.40 (PLA, 1 pc)The exact price comes from the calculation once the file is uploaded.

About the model

This is a slimline case for the HAS (Home Arcade System) JAMMA Extender. This case allows the extender to be plugged into arcade boards that are in cases that may not allow enough clearance to use the standard extender plexi case. When printing this I used PLA+ with the following overrides to the defaults in Cura: • Wall Line Count: 4 • Top Layers: 6 • Bottom Layers: 6 • Infill Density: 30 Depending on your material the above may or may not be needed, I found default settings with PLA+ didn't provide the rigidity that I required.

Similar models