Fred The Frog, but a large magnetic container

About the model

I wasn't sure about printing the existing screw-fitting Fred container at large size and I thought it'd work well using magnets to attach the lid. This is created from the “resculpted” version of Fred the Frog. It requires eight 6x2mm magnets which should “push” fit into the holes with a tiny bit of force and then hold. If not you may need to widen the holes slightly and/or use a tiny dab of glue on the magnet. To print it smaller you'd need to replace the magnet holes. I originally intended to create a lip around the hole which would fit into a recession in the head for additional stability, but meshmixer did not want to co-operate.