Sonic Pad Mount
MakerWorld · chrscoop
by NathanMichaelMoore · Printables
The licence (CC BY-NC-SA (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.
Upload the file and printThis is a filament dry box I made for printing nylons. It is inspired by the Markfoged drybox but way cheeper. This uses a Monoprice 9.9 L waterproof hard case and some PTFE fittings and tubing. It can hold two spools of 1KG filament. You will need a 10mm rod to used included files although you can always make your holder or remix this one to fit whatever rod you have. total build cost $40 BOM (Amazon Links): 1) Dry Box 2) PTFE Hardware 3) 10mm Rod cut to 157mm 4)Printed Parts Filament I am printing is SainSmart ePA-CF Prints really nice! Note: These are affiliate links so I get a kick back if you use them. Print instructions Material: PLA or PETG Layer Height: 0.2 Infill: 20% Assembly instructions: After printing, insert tabs into box then glue the spool holding members. Gluing them in the box ensures to correct for differences in printers and different dry box dimensions. Be careful not to glue it into the box unless you want it to be permanent. Then drill holes for the PTFE fittings in the general area shown in the photos above. If you use a smaller hole then the thread OD there is no need to tap as they will self tap as you screw them in. Finally insert desired length PTFE tubing and your good to go. Happy Printing!
MakerWorld · chrscoop
MakerOnline
MakerOnline · haietom
MakerOnline · Flonfli
MakerOnline · Adivor
MakerWorld · Frontier
MakerOnline · F96
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies