Cat Phone Stand
another site · Sparks3D
by jonnieZG · Printables
The licence (CC BY-NC (non-commercial)) allows non-commercial use only. Download the file at the source, upload it to us and print it on the rented printer for your own use, not for sale.
Upload the file and printOriginally the remix of the ingenious Car Vent Gravity Phone Holder by Abdel Darwish that in the version V3 I remodeled from the scratch, keeping the original idea and general outline. Main changes in V4 (2025-07-26) • Changed parts: • Arm • Sled • Clip • Clip Knob • Sled: Thicker pins that hold the arms (reported breaking in some cases) • Arms: Bigger hole for the pins. • Clip: • The clip profile changed to prevent its jaws from deforming when using for a long time in a hot car • The tip is remodeled for better grip • Clip: Remodeled to accept a screw for plastic (diameter 2.8-2.5mm, length 6-10mm) • Clip Knob: Added a hole for the screw • NOTE: The screw holding the clip to the clip knob is optional, but highly recommended. Main changes in V3 • Remodeled body for tighter tolerances (in previous versions sometimes the front and the back plate would detach) • Clip remodeled for better grip and easier removal from the fins when needed • Tighter Clip + Clip Knob for click-fit • Sled remodeled for a phone to sit better • Arms remodeled for faster print Main changes in V2 • The clip can rotate to adjust to various vent fins • Openings in the body to allow air to pass and cool the phone • UPDATED 2022-09-01: a “hooked” clip with a stronger grip to the ventilation fins and a longer “long” clip, also with a stronger grip. Try and see which one suits you best. Longer arms to allow access to volume buttons for Huawei, Samsung and iPhone Press the Clip Knob to the Clip - it should snugly fit. It is highly recommended to fix the two with a screw for plastic, diameter 2.8-2.5mm, length 6-10 mm. Alternatively, fix the two with a tiny drop of superglue. There is no need for the glue if you use a screw. Do not glue the clip to the body. It must be allowed to rotate. Print Settings Printer: • Prusa CORE One Rafts • No Supports • On Build-Plate only Resolution • 0.20 Infill • Clip: 90% Gyroid infill • Other parts: 30% Gyroid infill Filament • ASA (Highly recommended) or other temperature-resistant filament • PA / Nylon (best), ASA, or PETG (a non-brittle one) - The clip could soften when the car heating is on. Category: Mobile Phone
another site · Sparks3D
another site · TaxiLab
matplace
another site · Kiron21
Printables · Josh-3d
MakerWorld
Printables · FireZ
MakerWorld · trudonr
Cookies and measurement. The necessary cookies are always on; visit measurement and ads only with your consent. More about cookies