Airplane print in place

About the model

Beautiful one piece airliner print. You can choose version without stand mounting holes, or version with stand mounting holes. There are also stand model for the plane. Print settings -Nozzle 0,4 mm -Layer height 0,12 mm -Perimeters/wall line count 3 -Infill 20% Print instructions -Find out best Z-seam setting for hiding the seam -Raise the model lowest point 2 mm above build plate, you may change your slicer setting to allow that. (See picture how to switch that setting in Cura) -Recommended model alignment exactly horizontal. (See picture from slicer) -If stand mounting pins fit too loose, you can use some glue, or tweak your slicer settings -Use support blocker below plane stand mounting holes if printing stand version Minimum build plate size: 203 mm x 175 mm Please ask if you have any questions or improvement suggestions!