matplace
2-Tone Spiral Planter

2-Tone Spiral Planter

by Jacob Rempel · Printables

This model cannot be printed on matplace

Its licence (CC BY-NC (non-commercial)) does not allow printing to order. You can download the file at the source and print it yourself.

models to print
Licence
CC BY-NC (non-commercial)

About the model

Use either PLA or PETG INNER SECTIONS: • Vase mode/spiralized outer contour recommended OUTER SECTIONS: • No supports needed • Use settings optimized for overhangs and retractions (there are a lot of both) • A 0.6mm nozzle will reduce print times and is generally an excellent investment This planter can be used for most plants. I don't recommend super thirsty plants, however, as the drainage area is small. It is best to plant in the inner section BEFORE putting it into the outer section, and it's wise to fill the narrow bit with pebbles for drainage.

Similar models