Ender 3 S1 cable holder/guide | Pro | laser modul

Be one of ten who leave a Like at Printables and support me with it :) The new version 04 allows to use the original holder of the laser module. For the assembly, the extruder must be disassembled by means of 4 screws and additionally 2 screws of the original cable holder. V3.1 and V3.2 are a simple design - plug & play without disassembly of the extruder. Of these two models, I personally prefer V03.1 as it is the easiest to assemble. The brackets have been designed to use the full installation space of 220x220x270mm. If the part helps you, I would be very happy about a make :) Printer: Creality Ender 3 S1 Pro Walls: 3 Filling 20% for V04   Do not forget to also install the cable guide for the heating bed cable.   Check out my other designs too!