Unknown source
Taylor Swift Bookmark - Hueforge Print
Zdarma
stažení modelu zdarma
196
Likes
Print parameters
MaterialPLA
Indicative parameters recommended for download. The printer may adjust them as needed.
Model license
Free – personal
Free for personal non-commercial use.
⚠
Pouze pro osobní použití — licence neumožňuje prodej tisku. Můžete si ho nechat vytisknout pro vlastní potřebu (tiskař vám poskytuje pouze službu tisku, ne obsah modelu).
Added 21. 5. 2026
Description
Ever wanted Taylor Swift to stare back at you as you stop reading for the night? With this bookmark, allow Ms. Swift to not only mark where you are in your book, but also guilt trip you with her eyes as you slowly shut the book in her face.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm
Filaments Used:
• PLA Siddament Black Transmission Distance: 0.2
• PLA+ Sunlu Grey Transmission Distance: 1.4
• PLA Sunlu Beige Transmission Distance: 8.2
• PLA META Sunlu White Transmission Distance: 9.6
Swap Instructions:
• Start with Black
• At layer #13 (0.68mm) swap to Grey
• At layer #22 (1.04mm) swap to Beige
• At layer #30 (1.36mm) swap to White for the rest.
This is a thin print. Make sure your filament has been calibrated to be able to handle the low layer height!
Similar models
Zdarma
Zdarma
Zdarma
