Sunlu Filadryer S1 Plus/S2 Dryer Rack

Dryer rack that fits like a spool inside your Sunlu Filadryer S1 Plus/S2. Gaps are 1mm wide so your Silica Gel beads wont fall through. Works well with bags and loose beads. Depending on what material you print with you can crank up the temp, I wouldn't go higher than 50c with PLA due to vicat softening, however printing it in PA-CF and you can crank it up as high as the dryer will go. But whatever temp you usually dry that filament at would work, just takes longer the lower the temp. If your desiccant is really saturated you might want to leave a gap in the lid. Designed to be snap fitted together, but really no reason to pull it a part so might as well super glue the parts together.   Update: I've uploaded a printing profile with each side on different plates so the model wont print over the calibration lines, as well as configure it for PLA, PA-CF, ASA and ABS