matplace
Simple Sanding Block / Sanding Tool

Simple Sanding Block / Sanding Tool

autor PrismaPrints · Printables

Máte soubor? Vytiskněte ho na naší tiskárně

Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)
Největší rozměr
asi 150 mm
Odhad tisku
asi 42 g filamentu, 1 h 35 min
Cena u nás
od 128 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

This is a three part sanding block, made to be very easy to put together. Scale as you like, but be wary when scaling down, the bolt may need more clearance. At 100% scale needs about 19cm of sandpaper.   Recommended settings (best to use PLA+ or PETG) Main block: 20% infill or more, 0.2mm layer, no supports needed Bolt: use 40% infill, ideally PETG, 4 wall lines, 0.1mm layer. Wedge: Use whatever settings None of the parts require supports. The clearance test is used to figure out if there's enough clearance without wasting material.    

Podobné modely