Round Lithophane Lamp

Lithophane Settings added as a Text documentMount v1 & Mount v2 are just for show, so you can view the full model in 3D, DO NOT print these for use.Base:0.2 Layer HeightSupportsThe hole in the bottom for a lamp is 50mm.Roof:0.12 Layer HeightAtleast 4 Walls (might be small gaps in the roof otherwise)Base-Lamp Holder:This is if you have an existing lampbase you want to use. It goes over lampbase (I use E14) and the printed Base then rests on top of it and make you able to spin the Base around freely. The hole of the Base-Lamp Holder is 29mm and the bottom of the Base has a 80mm hole, you might have to customize to fit the lamp youre putting it on. Foot v1 & Foot v2:Haven't printed any of these, 0.2 Layer Height should be fine.The whole in the top of these are 30mm to make room for a lamp, the Base is then placed on the Foot. You might have to customize to fit the lamp youre putting it on.