Printables.com

Medal holder - artistic dance design

Zdarma stažení modelu zdarma

Print parameters

MaterialPLA

Indicative parameters recommended for download. The printer may adjust them as needed.

Model license

CC BY-NC-SA Non-commercial use, credit required, share under same license.

⚠

Pouze pro osobní použití — licence neumožňuje prodej tisku. Můžete si ho nechat vytisknout pro vlastní potřebu (tiskárna vám poskytuje pouze službu tisku, ne obsah modelu).

Original author: Roary Labs · Originál na Printables.com

Added 6. 5. 2026

Description

This is a medal holder that you can hang on your wall. Is made out of 5 parts, that can be mounted without glue or screws, just interference (there is a lot of interference, but if you push enough, you will be able to assemble it). If you have difficult sliding it in the lower part, use a little bit of oil lube and a rubber hammer. You must print it using SUPPORTS, between the parts where the 5 pieces are going to join. Be careful, remove all the excess otherwise you are going to have problems while mouting it. To hang on the wall you need this type of hooks: https://lc.cx/IwnjzK Credit to https://www.klipartz.com/it/sticker-png-bzwko for the figures used in this design If you have problems, contact me! If you like it, leave a like and a comment, thanks :)