K2Clip Filament Clip - K2 Clip

The K2 Clip WATCH THE VIDEOS BELOW! The K2 Clip is a unique filament clip design with multiple locking points. No matter what, there will be a locking point facing up. The clip can be left to "float" on your filament spool while printing. Extra secure storage using the locking center!    NOTE: I recommend taking them off when using the Bambu AMS.    Don't forget to Follow!  Thank you so much for your Downloads, Like and BOOSTS!   NOTE: All printers are different, and calibrated differently. The K2 Clip has very tight tolerances. Test print one in case you need to scale the X/Y up or down. ______________________________________________________________________________________________   ❤ How-To by FilamentStories ❤  https://www.youtube.com/watch?v=xv6aaTB9OwY&ab_channel=FilamentStories     JJ Shankles Video: https://youtube.com/shorts/xuDetHdQee8     ❤ Featured on BV3D: Bryan Vines “3D Printed Tools for 3D Printing” @ 06:15s     Don't forget to ❤ Like and ★ Rate! Q&A: • How do I use the K2 Clip? • Insert the end of your filament through the center hole and feed the clip around your spool until the end of your filament again meets up with your K2 Clip. • Press the end of your filament into the top of the K2 Clip. • Why so tight?!?! It's designed to be tight and hold your filament firmly. The K2 Clip will loosen after some use. • Why is it a triangle? Triangles are cool! No matter what, there will be a locking point facing up. • Should I remove the clip while printing? In your AMS, I would, otherwise Heck NO! I took lots of time designing/sizing/shaping/massaging that center hole to float on your spool while printing.