Horizontal Magsafe iPhone & AppleWatch Stand

Horizontal Magsafe and AppleWatch Stand This is a combined MagSafe iPhone and AppleWatch charging Stand that holds the phone horizontally to take advantage of the new StandBy mode in iOS 17. All cable cutouts fit both USB-A and USB-C cables and all models are compatible with all iPhones that have MagSafe and all AppleWatch models. Different versions of this design by me can be differentiated by the version number (just in front of the "M") while different suffixes indicate different variants of the model at the end of the file name. Available design variants: Four variants of V5 are available, and for each variant small and large bezel sizes are available as separate print profiles: • OriginalDesign: This is my original compact design, only allowing the phone to be held horizontally • VerticalPhone: This version is a bit longer and allows the phone to be held vertically, adding a third camera bump cutout for this position (requested by DonWhiteside on Thingiverse). • 2xMagsafe_noWatch: This is a version that replaces the Apple Watch charging spot with a cutout for a second MagSafe puck, e.g for charging your AirPods (requested by m_reiner on printables). • OnlyPhone: This is a version that removes the Apple Watch charging spot, not replacing it with anything if you don't need it (also requested by m_reiner on printables). If you expect more shrinkage on your Filament/Printer and would like a larger tolerance around the MagSafe-Puck, check out the 04mmTolerance Versions on my Printables. You can also find the older Versions 03 and 04 there if you want them. Update History: Update 17.10.2023   SmallBezel versions of each of the original four variants are now available. Update 05.10.2023 Version 05 is out! This Update adds a retaining mechanism in the cable channels on the bottom of all models. You need a bit of force to get the cables in, but it is easily possible and leads to secure retention in the channels, preventing them from sticking out. The AppleWatch Charger mount is also 3mm taller to allow for AppleWatchUltras with cases to better fit. I also added a new version of the design: "SmallBezels". This version has smaller bezels around the MagSafe Puck for those wishing for a more minimalistic design. Due to the smaller bezel, the cable for the MagSafe-Puck is no longer fully contained in the model. Update 28.09.2023 I've replaced all raw files and print profiles with versions that have a 0.2mm smaller tolerance on the MagSafe ring (now only 0.2mm bigger than the puck instead of 0.4mm), as the fit wasn't quite as snug as I wanted (I guess the X1C is just too dimensionally accurate compared to my old printer). Update 25.09.2023 Version 04 is out! This is a slight redesign of the edges, while also consolidating the naming scheme.   Miscellaneous I printed this in GlowInTheDark Blue PLA which looks very nice at night. If you want any other file types for a remix or something else just leave a comment and I'll do my best to provide them.