matplace
Flashforge AD5M - Enclosure attached tool holder

Flashforge AD5M - Enclosure attached tool holder

de Vic · Printables

¿Tiene el archivo? Imprímalo en nuestra impresora

La licencia del modelo (CC BY (atribución)) permite también el uso comercial. Descargue el archivo en la fuente y súbalo aquí. Anotamos el autor y la fuente en el pedido por usted.

Subir el archivo e imprimir
Licencia
CC BY (atribución)
Lado mayor
unos 110 mm
Estimación de impresión
unos 68 g de filamento, 2 h 36 min
Precio con nosotros
desde 7,60 € (PLA, 1 ud.)El precio exacto lo da el cálculo una vez subido el archivo.

Sobre el modelo

Un organizador de herramientas y boquillas se acopla directamente a la esquina izquierda de la carcasa de la Flashforge Adventurer 5M utilizando los tornillos del panel. Permite mantener ordenados los alicates, calibres, rasquetas, destornilladores y piezas de repuesto. Oriente la pieza sobre la base más ancha en la plataforma de impresión, aplicando soportes únicamente en el saliente destinado a los alicates de corte. Imprima a una altura de capa de 0,2 mm y elija filamento PETG, ya que ofrece la resistencia mecánica y térmica necesaria junto a la máquina.

Descripción original del autor (English)

This is a tool and nozzle holder for the Flashforge AD5M enclosure kit.It has been designed to fit to the far left corner and positioned to fit to the Standard Enclosure panel screw places. You will need to change the original M4 screws to a bit longer ones. It has room for all the standard AD5M tools and nozzles plus some more as you can see on the picture. You can add a scraper, there is a small box for stuffs like filament clips, you can add one more screwdriver and a Caliper.It was designed with a small offset of the nozzle holder to be able to remove the left side plexiglas panel without a hassle in case it's needed. Printing details: I made it from PETG with 15% infill, you can try PLA but I would go with at least 30% infill with PLA as it is less strong materialSupports: it needs support only for the cutting pliers holder (see the pic)With 15% it consumes about 167g material

Modelos parecidos