SKS (miniature gun)

Youtube video here:https://youtube.com/shorts/1AW4fd90yoo?feature=shareOnly the mag and frame need supports. A brim is recommended for the barel.(If the print file has any issues, please let me know) SKS- ASSEMBLY GUIDE 1. Magazine Section Assemble the three components as shown in the illustration.Use glue to secure the bottom cover in place.Prepare a small rubber band, approximately 7 mm in length or slightly shorter. Note: If the rubber band is longer than 7 mm, the magazine may not function reliably.Any type of rubber band can be used, but the following type is recommended:Using glue, carefully attach both ends of the rubber band to the positions indicated in the image.Insert a few bullet into the mag to test its function. Note: The mag has a maximum capacity of 4 rounds, but it is recommended to use only 3 rounds for stable operation. 3. Barrel Section First, ensure that all excess material inside the barel is fully removed. The bullet must be able to move freely without obstruction.Attach the two small components onto the barel as shown.IllustrationInstall the barel assembly onto the frame. Note: The edge of the barel must sit flush against the edge of the mag, as shown in the illustration.Apply glue to secure the barel and the Rear sight in place. 4. Hammer Section Prepare a spring with a length that nearly reaches the mag. Note: A relatively stiff spring is recommended. Suitable springs can often be found in click-type pens and will provide stronger firing force.If the spring is too long, the hammer may jam before reaching the locking position.Carefully insert the hammer in front of the spring, then use the cover to hold all components in place.Test to ensure the hammer is properly retained.Finally, apply glue to secure the cover. GOOD LUCK!