matplace
Pokémon Bulbasaur / Bisasam Planter

Pokémon Bulbasaur / Bisasam Planter

autor R3D · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC-SA (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC-SA (jen nekomerčně)
Největší rozměr
asi 85 mm
Odhad tisku
asi 45 g filamentu, 3 h 30 min
Cena u nás
od 180 Kč (PLA+, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

This Pokémon plant-pot has a lot of 3D surface detail and will decorate your window sill or sideboard or… every place! Updated Version: STL #2 is modified with an optional drain hole.  Still I'm marking this as a reupload since changes arent substancial. Fits:  Scale 60%: Every standard 5 cm plant pot. Best to plant a succulent or smal plant in it. Scale 120%: Will fit to any “normal” sized plant pot with around 10 cm diameter. Lore: Along with Charmander and Squirtle, Bulbasaur is one of three starter Pokémon of Kanto available at the beginning of Pokémon Red, Green, Blue, FireRed, and LeafGreen.  Remark: This model was desined by littlebala and published under CC Attribution Non-Commercial Share Alike. Printing Recommendations: 0.2 mm layer hight, 15 % infill, 3 perimeters. The model prints well without supports, but expect a slightly rough  surface around the front neck. Feel free to share and like or just print a whole army of them ;-) Want a cute watering can for your planter? Klick here: https://www.printables.com/de/model/254485-dodecahedron-watering-can

Podobné modely