matplace
Playstation 5 (ps5) horizontal stand

Playstation 5 (ps5) horizontal stand

autor Matt-G · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC (jen nekomerčně)
Největší rozměr
asi 450 mm
Odhad tisku
asi 285 g filamentu, 10 h 20 min
Cena u nás
od 682 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

one Foot is as big as the printbed from the MK3S so you can only print one at a time It is not a perfekt fit but close enough and does the job gerat I printed them with a 0.6mm Nozzle with 0.2 mm layerhight and 4 outer shells. hope you like it^^ DE: Ein Fuss ist so gross wie die Druckfläche des MK3S, somit lässt sich nur ein Fuss auf einmal Drucken Der Fuss ist nicht Perfekt aber macht seinen Job gut. Ich habe mit einer 0.6mm Nozzle und einer Schichthöhe von 0.2mm gedruckt. Ausserdem habe ich noch die Aussenhülle mit 4 Layer gedruckt. Hoffe du hast daran freude.  

Podobné modely