matplace
Olaf cookie cutter

Olaf cookie cutter

autor Coarse · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC-ND (jen nekomerčně, bez úprav)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC-ND (jen nekomerčně, bez úprav)
Největší rozměr
asi 110 mm
Odhad tisku
asi 18 g filamentu, 1 h 29 min
Cena u nás
od 97 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Olaf cookie cutterTwo-part cookie cutter designed for easy use and good looking cookie. I mainly wanted the dough not to stick to the mold and for the edges of the cookie to be even and nice everywhere.Recommended Print Settings:Line width: 0.4mmLayer Height: 0.2mmInfill: 20% Wall Loops: 3Wall generator: Arachne (without this setting the cutting edge will be dull)The key to success is the dough and the corresponding pressure on the stamp. You can try the cookie recipe that I used.Butter cookiesIngredients for 40 cookies: 350 g medium ground flour, 150 g icing sugar, 130 g butter, 2 eggs, ½ pack vanilla sugar. orCinnamon cookiesIngredients for 40 cookies: 250g plain flour, 120q icing sugar, 100g butter, 1 egg, 10g ground cinnamonInstructions for both kinds of dought: Mix all ingredients, process into smooth dought and leave to rest in cool place for at least 2 hours. Cookies bake in the oven for approx. 10-12 minutes at 160°C.For more cookie cutters visit my profile.All my cookie cutter models work on the same principle and the results should be as good as the video below.

Podobné modely