matplace
iPad Stand

iPad Stand

autor TechGuyChad · Cults3D

Máte soubor? Vytiskněte ho na naší tiskárně

Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)
Největší rozměr
asi 180 mm
Odhad tisku
asi 85 g filamentu, 3 h 15 min
Cena u nás
od 230 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

Design updated (02/1/24) - The old version I believe was not holding the iPad up when turning the device upright. This newer design should hold up better. This iPad stand I designed is holding my Apple iPad Air 2 but should work with most iPads. 125mm (wide) x 65mm (deep) x 58mm (tall)

Podobné modely

Stand

MakerWorld · Flash Gordon