Cat Stretch Voronoi Remix
Printables · Peter
Cults3D
Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.
Nahrát soubor a vytisknoutI intend to print this out in very high resolution and found the original mesh was a little jagged in places, especially the teeth and eye sockets (original vs new mesh in thumbnails..). I increased the subdivision on it from about 260,000 poly's to 3,000,000 polys, sculpted some details back in, smoothed as much as I could without going blind, flattened it and centered it, scaled it to 10cm height then cut it back from 388mb to about 30mb, which sliced in no time at all. After reading some of the comments from people that have printed them before, and seeing it can be done without supports. I did a couple of test prints and added supports where needed, the chin will stay stuck, there is supports for under the back of the skull and most importantly the cheeks which really needed it. This should look fairly good when printed with an SLA printer I would imagine, there is alot of detail in it, thanks for the original Syfy.
Printables · Peter
Printables · 3DWP
matplace
Printables · Kleiner Lateiner
MakerOnline · moica
MakerOnline · Aitor2
MakerWorld · minivanbuzz
MakerOnline · SwotarCZ
Cookies a měření. Nezbytné cookies jsou vždy; měření návštěvnosti a reklamy jen s vaším souhlasem. Víc o cookies