matplace
Halloween Tea Light Display

Halloween Tea Light Display

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 150 mm
Odhad tisku
asi 285 g filamentu, 8 h 40 min
Cena u nás
od 632 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

** Get an early start! Get the Christmas version now! **     Light up different Halloween scenes in this display. A tea light candle is required. The display features a door that opens to allow access to the tea light. Use a section of 1.75mm filament inside the hinge to connect the door to the case. Depending on your printer/setup, this hole may be on the tight side or a bit loose. If tight, drilling out the hole may help. If it is slightly oversized, I suggest melting the end of the filament piece with a soldering iron or lighter. I have included a separate liner. This allows you to print the case in a dark color, but line the inside with a lighter color to allow for more reflection of light outward, making everything brighter. For a complete display, you will need: • 1x Case • 1x Door • 1x Knob • 1x Snap Ring • 1x Liner - Optional • 1x (minimum) Scene - You can easily remove the snap ring to swap out scenes as desired Check out my other holiday models here. Print Settings No special setting are needed for the display case, door, knob, snap ring and liner.   Scenes Print Settings Print the scenes with 100% infill. The scenes also require color changes: • The top 2 layers should be black • If there is no moon in the scene, all other layers can be white or clear - both look nice • If there is a moon in the scene, it will look best if the bottom 2 layers are printed in clear filament • All other layers should be white • All non-black layers could be printed in all white or all clear if one isn't available to you   Assembly Glue the knob into the door. Only a very small amount is needed. Put the door in place and latch it. Use a 20mm piece of 1.75mm filament to connect the 3 sections of the hinge. If the filament goes in very easily, it may be a good idea to heat up the top end of the filament ‘pin’ and press it flat. This will prevent the pin from falling through later on. Open the door. Insert a scene into the opening (image facing outward

Podobné modely