Gyro 7 Printable Jointed Cat
autor Neybao · Printables
Vytiskněte si ho pro sebe
Licence (CC BY-NC (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.
Nahrát soubor a vytisknout- Licence
- CC BY-NC (jen nekomerčně)
- Největší rozměr
- asi 140 mm
- Odhad tisku
- asi 78 g filamentu, 4 h 47 min
- Cena u nás
- od 268 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.
O modelu
The orange Gyro 7 in the pictures is printed in 0.20mm layer height Printing Material: PETG (PLA makes the joints too loose when using the normal skeleton and too tight for the tight Skeleton. Assembly is also more difficult in PLA.) Layer Height: 0.10mm - 0.20mm lower makes the ball joints work a bit smoother and the model looks nicer. Supports: None, But the ears have some model-in supports that can be broken off after printing all other settings are the system presets for 0.10mm - 0.20mmQUALITY Added the option to print them connected which helps printing the smaller parts. And makes assembly easier because it is harder to lose parts. also looks a bit nicer to give a kit(ten)-card to someone instead of a heap of parts. This one is printed at 0.15mm layer height. Added the option for a stiffer skeleton to make posing easier. but it might limit play a bit, something to keep in mind if for example it is intended for a kid My very simplified design process and the reason for the 7 Gyro 1 is my actual cat who got slightly annoyed I kept inspecting his legs on how they move. Gyro 2 was the first printed skeleton but the ball joints where to lose. Gyro 3 had a better skeleton and was the first with the plating but some parts where to lose and some too tight, one of the hind paws wouldn't go on. Gyro 4, 5 and 6 had a few parts that where too difficult to assemble. Gyro 7 finally assembled nicely but i did decide to make a small tool to help assemble the tail. Assembly Some Arrows are numbered to show the assembly order 1. all grey parts have a particular orientation look carefully. Especially with the smallest part. The black parts in the middle are the same. (for PLA: the body can be too loose) 2.1 The biggest black part DOES have a top and bottom note the protruding bit has chamfers and the “hands" for the ears have a curved corner 2.2 The head might need some force to be put in place (for PLA: The head requires more force to pu
Podobné modely
Buzz Lightyear Multipart Fanart
matplace
Cat
MakerOnline · Yang3D(
Stitch NO AMS
matplace
Streetwear Bowser Figure | Super Mario Urban Fan Art
Printables · Fluid Prints
Tom Cat
matplace
Flexi Factory and Bambu Lab Collaborative: Panda Bear and Stand
MakerWorld · flexi.factory
