matplace
Filament holder

Filament holder

autor DaveMeyer · Cults3D

Máte soubor? Vytiskněte ho na naší tiskárně

Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)
Největší rozměr
asi 110 mm
Odhad tisku
asi 85 g filamentu, 3 h 30 min
Cena u nás
od 237 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

This filament spool holder makes sure your filament spool is rotating smooth and concentric. It is printed 2 times and each part is inserted into one side of the hole of the filament spool. Then, a rail is inserted through the 2 smaller holes provided by the filament holder. The rail and the holder itself must be provided separately. This part was made for the ANET A6/A8 filament holder but it can be used for others, too. Project files for Creo Parametric are provided for customization. The diameter of the part should be suitable for most filament spools. But the diameter of the rail could be different depending on your setup. The other long holes in this part are just there to save up weight/material and to make it look cooler.

Podobné modely