matplace
Filament box / Spool holder / dry box

Filament box / Spool holder / dry box

autor firstgizmo · Printables

Vytiskněte si ho pro sebe

Licence (CC BY-NC-SA (jen nekomerčně)) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
CC BY-NC-SA (jen nekomerčně)

O modelu

Features: • Takes spools from 50mm up to 95mm width, with a 200mm diameter • No need for bearings or fancy hardware (only 3x10 and 3x20 bolts needed, or similar) • Can run on its back just fine! • PTFE Tube can be fitted in two ways • Low friction, self centering rollers inside • Easily loaded / unloaded • Straight forward printing • Can be fitted with a 45mm x 25mm hygrometer • Smal foot print  • Customizable   Printing: Depending on your preferences, you might print at least bottom and lid in their given orientation. They'll print fine without support, except the latch_splitted. If you are uncertain about your printers bridging capabilities, use support for the lid. For the latch however, a brim is needed.  Due to the parts sizes, youll need at least a printable hight of 215mm on your machine. This is also true for the X, Y dimension of your printbed. Maybe youll be able to fiddle with the parts orientation to get it going on smaler printers but i wont bet on it. I used a 0.6 nozzle, 0.35mm layer hight and two perimeters with 15-20% infill for lid, bottom, tags and latches. This made the print reasonably fast and sturdy enough. 0.15mm layer hight for flange, screw_cap and cap will work fine as well. For them i used a 0.4 nozzle. I didnt try them with the 0.6 one, so feel free to try it your self.   Assembly: 1)  Put rollers(6x) into bottom   Make sure to rotate them in such a way that the markings “INSIDE” will face the opposing roller. The BIGGER diameter of the roller must ALLWAYS be on the spool boxes inner side.           Start bolting the rollers with the outside first. The inner side is best be fastened then by holding the bolt in place and spinning the roller with your fingers.  M3x10 up to M3x20 bolts will work here, but the shorter ones are installed more easily of course       All six rollers in place. Make sure not to tighten them to hard and to leave them spinning freely                 2) Fit the lid   Just put

Podobné modely