matplace
Ergonomic Oblique Calligraphy Pen Nib Holder

Ergonomic Oblique Calligraphy Pen Nib Holder

autor Jacky Wu · Printables

Máte soubor? Vytiskněte ho na naší tiskárně

Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)
Největší rozměr
asi 140 mm
Odhad tisku
asi 18 g filamentu, 1 h 35 min
Cena u nás
od 100 Kč (PLA+, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

To build this nib holder, please follow below guide: Parts or tools required: • Oblique flange (Dip pen flange) Go search in Ebay or AliExpress. • 2mm Drill Bit (Optional) • Hacksaw with nearly 1mm thick blade (Optional) Build steps: • Print the nib holder and get the parts. Please prevent to put supports in the slot. • Push flange into the slot of nib holder. • (Optional) You may need to use the 2mm Drill Bit to make the center hole larger and remove support/waste in the center hole • (Optional) You may need to use the hacksaw to saw a little bit if there any support/waste in the slot. • After push flange into the slot of nib holder, you can put your favorite nib and start writing! Feel free to remix and thanks for making this. Print Settings Printer: DIY 3D Printer Rafts: Doesn't Matter Supports: Yes Resolution: 0.1 Infill: 25% Notes: 25% infill is good balance for me about the weight. Please prevent to put supports in the slot otherwise you may need to drill and saw the slot. Category: Art Tools

Podobné modely