Google Nest Gen 2 Wired Doorbell Spacers (Flat & Angled)
MakerWorld · bri0nac
MakerWorld
Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.
Nahrát soubor a vytisknoutI had an issue to where the surface that I had my laser engraver on, was too smooth and would shift the engraver around with the rapid moves. I created these stabilizing feet to place on each corner to keep it from moving. There are no special requirements for printing, as long as your model doesn't split when screwing it down. I used small self-tapping screws to secure them to the table, but I cant remember what size they were, as I've thrown away the box of the fasteners. These feet are not just limited specifically to laser engravers. These can also be used to secure any square shaped object steady as they have a fairly low profile.
MakerWorld · bri0nac
MakerWorld · R C 3D
MakerWorld · IXPatch
MakerWorld · Ukdavewood
MakerWorld · keeeal
MakerWorld · vr6syncro
MakerOnline · FlwidPrint
MakerOnline · FlwidPrint
Cookies a měření. Nezbytné cookies jsou vždy; měření návštěvnosti a reklamy jen s vaším souhlasem. Víc o cookies