One Ring - Dual Print and Lithophane - Hueforge Print
MakerWorld · cyanidesugar
autor Ken · Printables
Licence modelu (CC BY (s uvedením autora)) dovoluje i komerční použití. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.
Nahrát soubor a vytisknoutCurved Lithophane Box.I wanted to make some lithophane lightboxes for some gifts and I found lots of good ones. However, I wanted one that was curved, held just one lithophane, and had a completely enclosed light box, and I just wasn't finding what I wanted. So I jumped into Fusion 360 and came up with this design.Print the LithoBody.stl and LithoLid.stl models first. Flip the LithoLid over before you print it. No supports are needed. I used a 0.6mm nozzle with 0.3mm layer height. It worked great and only took about 3 hours for the body, 1 for the lid. A 0.4mm nozzle with 0.2mm layers works good too, but it will take twice the time. Instructions for printing the lithophane are at the bottom.Electronics Parts list:12V LED light strips. https://www.amazon.com/dp/B00HSF65MC/ref=cm_sw_su_dp On/Off Switch: https://www.amazon.com/gp/product/B07SPY9H7Y/ref=ppx_yo_dt_b_asin_title_o06_s00?ie=UTF8&psc=1 LED Strip Connectors: https://www.amazon.com/gp/product/B01DM7EXX2/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 DC Power Supply and Connector: https://www.amazon.com/gp/product/B08BRPK9J9/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Zip ties: use whatever you have on hand that fits.Assembly:Insert the DC Female Terminal Connector into the hole in the back of the model. There are two printed supports inside the model that will hold it into place. It will be a tight fit, but once you snap it down in there, its not going to move.On the LED light strips, cut off two segments of 3 LED lights. Look for the cut marks on the strips. Insert the LED strips into the LED Light Connectors. The wire from the connector gets routed back through the slot at the bottom of the LED pillar on the model. Then zip tie the connector to the model, routing the zip tie through the slot on the side of the LED pillar. After the connector is secured, remove the backing from the adhesive of the LED light strip. The adhesive will help hold the LED strip to the mo
MakerWorld · cyanidesugar
matplace
MakerWorld · 3DPrintBunny
Printables · MeasureOnce
MakerWorld
Printables · Carl D
Printables · RetromanIE
Printables · LMF5000
Cookies a měření. Nezbytné cookies jsou vždy; měření návštěvnosti a reklamy jen s vaším souhlasem. Víc o cookies