Car Door Trash Bin

O modelu

Small trash bin to install in any door of any car.   Before you start choose the correct size for your car You need to measure the space available on your car door to install the trash bin and choose the size that best suits you. Isn't the size you need available? Let me know and I'll be happy to add it! Did you know that I have another trash can to install in the can holder of your car? Check it out!   Necessary materials • 2x m3 nuts. • 2x m3 x 30mm screws. • Small bags, such as these for dog poops 💩.   Printing instructions You need to print 1 Lid, 1 Bin and 1 Holder of the right size for your car, make sure all 3 parts are named with the same size. All parts are already oriented to be able to be printed without supports. There are some bridges but they are in non-visible areas. PLA is not a suitable material for this model since cars reach sufficient temperatures for it to melt, I personally recommend using PETG since it is very easy to print and will more than withstand these temperatures, but you can also use other more resistant materials like ABS or ASA. It is recommended that the holder material has some flexibility, the other parts can be completely rigid.   Assembly instructions • First insert the two nuts into their holes in the lid. • Now put the lid and the bin together and proceed to hold them with the screws, do not tighten the screws too much to allow the movement of the lid. • Insert the bag through the hole of the holder, make sure the opening of the bag is on the side where the holder clips are. • Fold the edge of the bag over so that it wraps around the holder. • Insert the holder through the bottom of the bin until the clips hold it in place, the edges of the bag should stay clamped between the holder and the bin. • Now all you have to do is install the bin on the door of your car.   Changing the bag • Remove the trash bin from your car door. • Squeeze the holder in the center until you can pull it out of the bin from