matplace
Buildplte-Holder  X and P Series

Buildplte-Holder X and P Series

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 140 mm
Odhad tisku
asi 45 g filamentu, 2 h 36 min
Cena u nás
od 162 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

i designed a Buildplate-holder for 7 Plates , designed in Stairs so you can see the front of every plate for reading or seeing the desing.   I designed in 2 parts so it fits on the printbed at once. i desinged conectors as well , i did not need any glue for fitting it . i printed standing on the Bambu-Logo→ less filament changes , also then is no support needed. printed in 0.20 layers , 2 perimeters , 3Bottom/Top. i did a pause before th toplayers and fill some steelballs in for some wight, so i used grid-infill 10%.    

Podobné modely