matplace
Bambu Lab X1C Top Glass Riser

Bambu Lab X1C Top Glass Riser

MakerWorld

Vytiskněte si ho pro sebe

Licence (jen pro osobní použití) dovoluje jen nekomerční použití. Stáhněte si soubor u zdroje, nahrajte ho k nám a vytiskněte na pronajaté tiskárně pro vlastní potřebu, ne na prodej.

Nahrát soubor a vytisknout
Licence
jen pro osobní použití
Největší rozměr
asi 110 mm
Odhad tisku
asi 28 g filamentu, 2 h 36 min
Cena u nás
od 142 Kč (PLA, 1 ks)Přesnou cenu spočítá kalkulace po nahrání souboru.

O modelu

NOTE: You need to Print - Both 3MF from me! (4 Parts) Hey :) I remixed the “Bambu Labs Carbon X1 Top Glass Riser for LED's” Now you can print it without TPU and it works better, we made some updates to the file! 1. 2x 3h printing time - 2 parts fit on the X1C. 2. no TPU needed anymore because we put the part together as one part. We now use 20x2mm EPDM tape as a base for the glass! This seals better, makes no noise and saves us the unnecessary TPU print! 3. we have adjusted the socket a bit so that we can better route the cable to the outside. To the parts list. 1. approx. 130cm 8mm COB Led strip 2. one power supply depending on what LED strip you bought (12/24V) 3. a dimmer if you want, we use an Alexa compatible dimmer. 4. cyanoacrylate glue 5. 20x2mm EPDM (foam rubber) tape for printing: You print everything from PLA, PETG, ABS in your Bambu Lab with a 0.2 er layer height and normal support (no tree structure please) Check the pictures to see how it should look. Always 2 parts just fit on the plate. Approx. 6h printing time for all 4 parts. (2x 3h) Assembly: We use the following "COB LED strips" in addition a "24V 1A power supply" and the following "EPDM tape" in 20x2mm. After printing, you clean up the parts roughly and just click them together, then you make a test whether it fits in the printer, it should lie flat in the printer without wobbling! If it does not fit, check your print for any warping.... After everything fits, you now glue the EPDM tape in the upper edge, this normally requires no superglue (grease-free). Then you cut the appropriate lengths for your LED tape, this depends a bit on the divisibility of the strips. Now solder all 4 strips correctly at +/- together. Leave the cables between the LED strips about 3cm long. After soldering, insert the LED strips into the intended lip, this should work with an 8mm strip without any problems, we had self-adhesive LED strips, but we still secured it at each divisible point from above with a d

Podobné modely