matplace
Christmas decoration

Christmas decoration

autor Pieter · Printables

Máte soubor? Nahrajte ho a nechte vytisknout

Licence modelu (CC BY (s uvedením autora)) dovoluje tisk na zakázku. Stáhněte si soubor u zdroje a nahrajte ho k nám. Autora a zdroj uvedeme u objednávky za vás.

Nahrát soubor a vytisknout
Licence
CC BY (s uvedením autora)

O modelu

parts neededWhite PLA or PETGGlueBatteriesWhite lights with battery holder (I used these)2mm foamAssemblyMake 3 rectangles of 2x1 cm from the foam and stick them as in the photo. Take the lights and put them through the hole and press the battery holder in place.     2. Press the middle tree (2) into its slot and use hot glue to hang the light on it. It should                look something like this. Note that for the best result you should orientate the lights                    towards the tree. I did not use all 20 lights, I cut the rest.     3. Press the small tree (3) and the deer (5) into its slot and glue the big tree (1) to the back.            then it should be ready.If there are any problems, send me a message and I will do my best to help. Good luck and have fun printing

Podobné modely