matplace
Christmas decoration

Christmas decoration

by Pieter · Printables

Do you have the file? Upload it and have it printed

The licence of the model (CC BY (attribution)) allows printing to order. Download the file at the source and upload it to us. We note the author and the source on the order for you.

Upload the file and print
Licence
CC BY (attribution)

About the model

parts neededWhite PLA or PETGGlueBatteriesWhite lights with battery holder (I used these)2mm foamAssemblyMake 3 rectangles of 2x1 cm from the foam and stick them as in the photo. Take the lights and put them through the hole and press the battery holder in place. 2. Press the middle tree (2) into its slot and use hot glue to hang the light on it. It should look something like this. Note that for the best result you should orientate the lights towards the tree. I did not use all 20 lights, I cut the rest. 3. Press the small tree (3) and the deer (5) into its slot and glue the big tree (1) to the back. then it should be ready.If there are any problems, send me a message and I will do my best to help. Good luck and have fun printing

Similar models